購買設計請充值后下載，，資源目錄下的文件所見即所得，都可以點開預覽，，資料完整，充值下載可得到資源目錄里的所有文件。。。【注】：dwg后綴為CAD圖紙，doc,docx為WORD文檔，原稿無水印，可編輯。。。帶三維備注的都有三維源文件，由于部分三維子文件較多，店主做了壓縮打包，都可以保證打開的，三維預覽圖都是店主用電腦打開后截圖的，具體請見文件預覽，有不明白之處，可咨詢QQ:1304139763===========題目最后備注XX系列，只是店主整理分類，與內容無關，請忽視
摘要
摘 要
此次畢業(yè)設計任務是對3L-10/8空氣壓縮機曲軸零件的機械加工工藝、夾具的設計,在曲軸零件的加工工藝過程中軸與軸中心線之間要有位置要求, 以毛坯軸兩端定位先加工兩中心孔,以兩端中心孔定位再粗、精加工各軸的表面，然后以粗、精后的兩軸徑定位鉆螺紋、銑鍵槽和銑曲拐端面，采用專用夾具加工兩斜油孔，最后粗、精磨各軸。
在夾具的設計過程中，主要以V形塊和支承板（釘）來定位，靠直壓板和彈簧來夾緊，鉆拐徑兩孔應采用長型快換鉆套，在鉆拐徑傾斜的孔時采用平面傾斜的夾具體，在鉆拐徑傾斜的孔時使用的是臥式鉆床，銑面時2個V形塊與銑刀不能干涉，因此V形塊高度要降低，夾具設計要方便、簡單。
關鍵詞: 曲軸，加工工藝，夾具設計
I
ABSTRACT
ABSTRACT
This graduation project duty is to the 3L-10/8 air compressor crank components machine-finishing craft, the jig design, between the crank components processing technological process middle axle and the axle must have the position request ,processes two center bores first by the semifinished materials axis both sides localization ,by both sides center bore localization again thick, precision work various axes surface.Then after thick, the essence two axle diameter localization drills the thread, the keyseat and the mill crank end surface uses the unit clamp to process two slanting oil holes, finally thick, correct grinding various axes.
In the jig design process, mainly locates by V shape block and the support plate, depends on the straight clamp and the spring clamps, drills turns diameter two to be supposed to use long trades quickly drills the wrap, when drills turns the diameter incline hole uses the plane incline the jig body, when drills turns the diameter incline hole uses is the horizontal-type drilling machine, when face milling 2 V shape blocks and the milling cutter cannot interfere ,therefore V shape block altitude must reduce, the jig design must be convenient, be simple.
Key words: crank, processing craft, jig design